13
El chorro de agua a alta presión que produce este equipo puede cortar la
piel y sus tejidos subyacentes causando una posible amputación.
La pistola rociadora acumula alta presión de agua, incluso cuando el motor está
detenido y el suministro de agua está desconectado, lo cual puede
causar lesiones.
El contragolpe proveniente de la pistola rociadora puede hacerlo caer.
1. For your protection, wear the protective safety glasses (provided).
2. Place the Pressure Washer near the working surface.
Make sure that the water source is turned on and all connections
to the Pressure Washer and Spray Gun are secure and without any water leakage.
3. Carefully remove the gun from its holder.
4. Completely unwind high pressure hose
from the hose reel.
5. Selecting the Right Nozzle for the Job.
To prevent damage to your surface and to select an
appropriate nozzle size for your application, always start with lowest pressure
nozzle size (Green) and continue changing to the higher nozzle size until the
best work result is achieved.
The Pressure Washer comes furnished with four spray nozzles. Each nozzle is color
coded and delivers a specific spray pattern and pressure for a particular cleaning
job. The size of the nozzle determines the size of the fan spray and the pressure out
of the nozzle.
0° Nozzle – Red: This nozzle delivers a pinpoint stream of pressurized water
and is extremely powerful. It covers only a small area of cleaning. This noz-
zle should only be directed at surfaces that can withstand high pressure such
as metal or concrete. Do not use this nozzle to clean wood.
25° Nozzle – Green: This nozzle delivers a 25 degree spray pattern for
intense cleaning of larger areas. This nozzle should only be used on
areas that can withstand pressure from this nozzle.
Chemical Nozzle – Black: This nozzle is used to apply special chemicals
and cleaning solutions. This nozzle produces the weakest pressure
stream of the four nozzles.
4. Connect the Pressure Washer GFCI power cord to a
dedicated electrical outlet.
5. Press the RESET button on the GFCI to ensure its
proper operation.
Outlet capacity must be 120V, 60HZ and minimum 15 AMP.
For best result, use a short garden hose (30 ft. or less length),
cold water (less than 100 F) and adequate pressure (no less than 50 PSI).
POWER SUPPLY CONNECTION
KEEP all electrical connections dry and off the ground.
NEVER touch the plug with wet hands.
NEVER cut or remove grounding blade (round longer pin) on GFCI
attachment plug.
MANTENGA todas las conexiones eléctricas secas y separadas del piso.
NUNCA toque el enchufe con las manos mojadas.
NUNCA corte ni retire la clavija de puesta a tierra (pata redonda
más larga) en el enchufe de conexión del disyuntor GFCI.
OPERATING THE PRESSURE WASHER
ALWAYS wear approved safety glasses when operating Pressure
W
ashers. Spray can splash back or propel objects, including
incorrectly attached accessories.
The high pressure stream of water that this equipment produces can cut
through skin and its underlying tissues, leading to possible amputation.
Spray gun traps high water pressure, even when the motor is stopped
and water is disconnected, which can cause injury.
Kickback from spray gun can cause you to fall.
SIEMPRE use gafas de seguridad aprobadas al operar lavadoras a
presión. El chorro puede salpicar hacia atrás o expulsar objetos
incluyendo los accesorios incorrectamente instalados.
To Next Page
Loading...
Need help?
General
