ControlTech
TM
Micro Wrench
9
MAINTENANCE / SERVICE
Contact your Snap-on sales representative for calibration or repair services.
CERTIFICATION
This torque-angle wrench was calibrated at the factory using angular displacement
and torque measurement instruments that are traceable to the National Institute of
Standards and Technology (N.I.S.T.). Torque parameters comply with ISO 6789-2003
and ASME B107.300-2010.
Note: No U.S. or International Standards exist for angle wrenches.
Clean the wrench by wiping with a damp cloth. Do NOT use solvents, thinners or
carburetor cleaners. Do NOT immerse in anything. Service, repair and calibration
are to be done by Snap-on Service Centers only. Contact your Snap-on Tools
representative. Ratchet head repair can be done by Snap-on Representative or user.
NOTES
- DO NOT use the torque wrench when powered off.
- Make sure the ratchet adapter used with the torque wrench is engaged properly
before using.
- Never force a ratchet adapter into the torque wrench Y-Shank receiver.
- If the display shows "ZEROTARE ERROR" at power on with no torque applied, the
wrench is damaged and must be returned for repair.
- The wrench must be held still during angle mode reset. Motion is indicated by
alternating segments of the display “- -”.
- Remove battery when stored for extended periods.
BATTERY REPLACEMENT
Note: When replacing batteries, real-time-clock will maintain date and time for 20
minutes.
Note: Turn End Cap counter-clockwise to unscrew.
Replace with Lithium "AA" cell only.
INSERT NEW CELL
NEGATIVE (-) END
To Next Page
Loading...
Need help?
General
