5
ZCTG861CE Rev. A (01/19)
13. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
14. Do not recharge non-rechargeable batteries.
15. Never attempt to connect two chargers together.
16. Have your charger serviced by a qualified repair person
using only identical replacement parts. This will ensure
that the safety of the charger is maintained.
17. For the location of the nearest Snap-on repair center,
please call Snap-on customer service at 1-877-762-
7664.
18. To reduce risk of battery explosion, follow these
instructions and those marked on the battery.
19. Never smoke or allow an open spark or flame in the
vicinity of the battery or engine.
20. Never charge a frozen battery.
21. Do not operate charger in a closed-in area or restrict
ventilation in any way.
22. Do not use an extension cord unless absolutely
necessary. If an extension cord must be used, make
sure that the:
— Pins on the plug of the extension cord are the
same number, size and shape of those of the plug
on the charger,
— Extension cord is properly wired and in good
electrical condition, and
— Wire size is large enough for AC ampere rating of
charger as follows
100-120 Volt
Charger
Cord Length (feet)
Wire Size (AWG)
25
50
100
18
18
18
220-240 Volt
Charger
Cord Length
(meters)
Wire Size (mm)
50
75
0.75
1.0
Recommended Extension Cord Length
SAVE THESE
INSTRUCTIONS
Functional Description
C
D
E
B
A
Figure 1:
A TRIGGER
Squeeze the trigger to
turn the instrument on.
Release the trigger and
the last reading is held
on the display for
approximately 7
seconds. If the laser is
activated it will only
come on when the
trigger is pressed.
B
°C
°F
:K
Short Press: Toggles
between °F/°C on the
display.
Long Press: Activates
contact temperature
measurement with a
probe.
C
REC
Short Press: Activates
the REC function.
Toggles between Min/
Max on the display.
Long Press: Used with
E button to turn on and
off Alarm.
D
Short Press: Activates
the Emissivity function
(E will flash). Use or
to adjust.
Long Press: Turns on
and off lasers and
backlight.
E LASER PORT
Target must be
centered in the laser
pointer circle.
To Next Page
Loading...