34
4-18
4-19
3
4-15
4-20
Layout
4.7 Help information
Help information explains the current action and, in
the case of an error code, provides hints for remedy.
Display help information
— Press the HELP key (Fig. 4-15, Pos. 3).
The ! rst screen with help information appears, e. g. to
the screen RIM DATA INPUT (Fig. 4-18).
— Press the HELP key once more to display the next
screen with help information.
(if present)
The second screen with help information to the screen
RIM DAT
A INPUT (Fig. 4-19) appears.
Note:
On pressing the HELP key in the last screen with help
information the display jumps to the ! rst screen again.
Quit help information
— Press the ESC key (Fig. 4-15, Pos. 2).
4.8 Electromechanical stop
Refer to Figure 4-20.
To perform an immediate stop:
• Press the Electromechanical stop button;
The electronic brake is activated to immediately stop
wheel shaft rotation, as well as any other balancer
(Lifter) automatic movement.
In the event of a stop due to an unexpected action by
the unit, reconstruct the steps taken
:
Did the operator make an error or omit to do
something?
Correct the input and continue working. No special
procedure is required.
Did the unit do something unexpected?
• Read the relevant chapters again.
• Prepare the unit for a restart:
switch off the unit
switch on the unit again.
• Carefully repeat the commands with the manual
available.
• If the unit does not function correctly,
WARNING: PREVENT ANY FURTHER USE OF THE
UNIT.
• Call the service team immediately.
To Next Page
Loading...
Need help?
General
