Snap-On EEWB334A - Page 74

74
5-33
5-34
5-35
5-36
20
21
28
26
Operation
5.10.3 Start optimisation/weight
minimisation.
Procedure:
— Clamp the wheel or bare rim.
— Enter correct rim dimensions, or check existing
inputs for correctness.
— Close the wheel guard (if necessary press the
START key).
— Starting from the BALANCING menu press key 20
Optimisation – Minimisation (Fig. 5-33).
The OPTIMISATION MENU “OP.1” screen (Fig. 5-34)
is displayed.
If an optimisation/weight minimisation result has
already been saved, press the 21 key (Fig. 5-35)
;
The program then continues from the step where it
was interrupted, with the relative measurement values
and the balancing optimisation / weight minimisation
may continue.
At this point, you can choose whether to continue with
Optimisation (Key 26), or go to Minimisation (Key 28).
5.10.3.1 OPTIMISATION
— Clamp the rim only.
—
Move the gauge arm into position on the rim, based
on the desired ALU.
— Perform a measuring run.
— In the BALANCING menu press key 20 (Fig. 5-33).
The “OP.1” screen page appears (Fig. 5-34).
— Press the menu key 26 (Fig. 5-34).
The OPTIMSATION “OP.2” screen (Fig. 5-36) is
displayed.