Snap-On PTRS1000 - Service Instructions; General Service Precautions; Torque Specifications

9
ZPTRS1000CE Rev. A (08/19)
Service Instructions
Service of a tool requires extreme care and knowledge.
Service should be performed only by a qualified service
technician.
• Always check tool for damaged parts before use.
• Replace or repair damaged parts before use. Check
alignment of moving parts. Binding of moving parts or
broken parts may alter operation.
• Have damaged parts properly repaired or replaced by an
Authorized Service Center.
• Do not use tool if trigger does not turn it on and off.
• Maintain tools. Keep tools dry, clean and free of oil and
grease for better and safer performance.
• For the location of the nearest Snap-on repair center, call
Snap-on customer service at 1-877-762-7664.
Torque Specifications -
PTRS1000
Inlet Bushing ....... 120-140 in. lb. (13.6-15.8 N•m)
Set Screws ..... ............ 15-20 in. lb. (1.7-2.3 N•m)
Adjustment Bolt ... ...... 15-20 in. lb. (1.7-2.3 N•m)
Inlet Adapter .......... ..... 40-60 in. lb. (4.5-6.8 N•m)