5
Important Safeguards
When using electrical appliances, basic safety precautions should always be followed including the following:
READ ALL INSTRUCTIONS BEFORE USING YOUR POPCORN MACHINE.
• Do not touch hot surfaces. Always use handles or knobs to operate.
• To avoid any risk of electrical shock, do not immerse cord or plug in water.
• Close supervision is necessary when operating machine near children.
• Unplug main power cord from outlet while not in use and before cleaning.
• Allow hot parts to cool down before moving or cleaning.
• Using any accessories or attachments not provided or recommended by the manufacturer may result in injury.
• Do not pop kernels in a dry kettle (without oil).
• Do not immerse the kettle in water.
• Kettle surfaces are HOT and should NOT be touched during the popping process or immediately after use.
• Unplug, clean and cover the unit while not in use. Store in a dry, safe place.
• Do not leave the power cord hanging over edge of table or counter, or allow it to touch hot surfaces.
• DO NOT place the unit on or near a hot gas or electric burner, or in a heated oven.
• Turn ALL switches to “OFF” position before disconnecting power plug from the outlet.
• Extreme caution must be used when unloading popcorn. Always use oven mitts!
OPERATING PROCEDURES
Please Note: If you are using your popper for the rst time, clean the interior of the glass surfaces and wipe the
inside of your popper with a clean damp sponge before heat is applied. Please follow these procedures for the
best operating results and long machine life.
Operation
• Place the corn popper on a dry, level surface. Protect from rain and other weather elements. Do not install near
pool or water.
• Plug the unit into a suitable grounded electrical outlet. (Please check the electrical specs. Be sure that your power
source matches the rating label specied next to the power cord).
• Open door and drop chute down. Hook kettle to main unit by sliding pins into side notches while aligning rod with
gear assembly. (Note: Push rod back until it snaps into place. Gears must be aligned to ensure proper meshing.)
Roller ball should be positioned on door side.
• Locate interior plug outlet on top-right panel. Flip open cover
and plug three-pin plug into outlet.
• Push chute back up. Firmly close door.
• The Main unit has 3 function switches: Kettle (Kettle Spin),
Warmer (Kettle Heat) and Power (Light / Warmer).
• Turn on the Power (Light / Warmer) Switch to activate the bottom
panel warmer and light.
• Turn on the Warmer (Kettle Heat) to preheat the kettle for
approximately 3-4 minutes. And also turn on the Kettle (Kettle
Spin) Switch to rotate the kettle arms. Pour ½ cup oil and 1½
cups corn into the kettle.
(Kettle Spin)
Kettle
(Kettle Heat)
Warmer
(Light / Warmer)
Power
To Next Page
Loading...