Snapmaker Laser Engraving

Need help?

Do you have a question about the Snapmaker Laser Engraving and is the answer not in the manual?

Summary

Before You Start

Get the Screwdriver Ready

Prepare the screwdriver for use.

Used Symbols

Explains various symbols used in the manual.

Transform into a Laser Engraver

Move 3 D Printing Module with Jog Mode

Use Jog Mode to position the 3D printing module.

Power Off and Unplug

Safely shut down the machine and disconnect power.

Detach Heated Bed

Disconnect the heated bed cable and remove it.

Attach Engraving Platform

Mount the engraving and carving platform.

Detach 3 D Printing Module

Disconnect the module cable and remove the 3D module.

Attach Laser Engraving Module

Install the laser module and connect its cable.

Connect Cables and Power On

Ensure correct cable connections before powering the unit.

Start Laser Engraving

Laser Safety Information

Read safety information before operating the laser engraver.

Place the Material

Position the material correctly on the machine bed.

Immobilize the Material

Secure the material using fixtures and clips.

Download Software

Obtain the necessary software from the official website.

Connect Computer and Power On

Connect the computer to the machine and turn it on.

Generate G-code

Create the G-code file for the laser job.

Set Work Origin

Define the starting point for the laser engraving.

Choose Engraving Method

Select the preferred method for laser engraving.