Snapper SC60V User Manual

7
ASSEMBLY
PART NAME FIGURE QTY
Chainsaw
1
Scabbard
1
Wrench - 13mm
(located inside
rear handle)
1
60-volt
2 Ah Battery
(SBA260V)
1
60-volt Charger
(SCH60V)
1
Bar and Chain
1
Operator’s
Manual
Pleasedo notr eturnp roduct to retailer.
Porf avor,nod evuelva el producto al lugard ec ompra.
Veuillezne pasr etourner le produi ta ud étaillant.
1-800-317-7833
www.snapper.com
WARNING:
ADVERTENCIA:
AVERTISSEMENT:
Lirele manuel d’instructions et bien respecterto usle sa vertisse-
mentsett outesl es instructionsde sécurité.Toutd éfautd elef aire
pourraitentraînerd es blessuresg raves.
L
OÑ
A
PS
E
H
SI
L
G
NE
F
R
A
N
Ç
A
I
S
Briggs & Stratton Power Products Group, LLC
Milwaukee, WI, USA
InstructionM anual
Manuald eI nstrucciones
Manueld ’Instructions
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury.
Lea el manual de instrucciones y siga todas las advertencias e
instrucciones de seguridad. El no hacerlo puede resultar en
lesiones graves.
60V LITHIUM-ION
CORDLESS STRING TRIMMER
Model ST60V
Rev. 00 07/30/15
1
Quick Start
Guide
QUICK START GUIDE
60V LITHIUM-ION
BRUSHLESS STRING TRIMMER
ST60V
ATTACHING THE GUARD
Missing parts, accessories or need a service center?
Do Not Return to Store
Call: 1-800-317-7833 www.snapper.com
1. Invert the string trimmer to access the
trimmer head.
2. Remove supplied screws (1) from the
trimmer head (4) with a philips
screwdriver (not included).
3. Place the guard (2) on to the trimmer
head.
4. Align the screw holes (3) on the guard
with the screw holes on the trimmer head.
5. Insert the screws into the trimmer
head, fastening the guard in place using a
Phillps head screwdriver (not included).
ATTACHING THE AUXILIARY HANDLE
INSTALLING AN ATTACHMENT TO THE POWER HEAD
2
3
4
Note: Remove the rubber insert that is
located in the shaft prior to assembling
the string trimmer.
1. Loosen the attachment knob (1) on the
coupler (5).
2. Push in the release button (2) located
on the attachment shaft (3). Align the
release button with the positioning hole
(4) and slide the two shafts together.
Rotate the attachment shaft until the
button locks into the positioning hole.
3. Tighten the attachment knob securely.
3
1. Press the auxiliary handle (1) onto the
power head shaft so that the handle is
angled toward the rear handle that allows
for comfortable operation.
2. Slide the auxiliary handle over the
holder (2) and ensure the holder fits
between the slots on the auxiliary handle.
3. Align the holes on the auxiliary handle
with the holes on holder.
4. Insert the handle knob (3) through the
auxiliary handle.
5. Tighten until there is no movement in
the handle.
2
1
STARTING/STOPPING THE TRIMMER
1. Ensure a fully charged battery is
installed into the string trimmer.
2. Place one hand on the trigger handle.
Place the other hand on the auxiliary
handle.
3. Press and hold the lock-out button (2)
and squeeze the switch trigger (1). The
string trimmer will turn ON.
4. Release the lock-out button. The string
trimmer will stay on as long as the switch
trigger is held.
5. Release switch trigger to stop.
1
4
2
3
1
5
LOOSEN
5
TIGHTEN
1
1
2
WARNING:
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user
must read and understand the operator's manual before using this product.
1
WARNING:
Read and understand
entire Operator’s Manual and follow all
warnings and instructions. Failure to follow all
instructions may result in electric shock, re
and/or serious personal injury.
UNPACKING
This product requires assembly.
• Carefully remove the product and any
accessories from the box. Make sure that all
items listed in the packing list are included.
• Inspect the tool carefully to make sure
no breakage or damage occurred during
shipping.
• Do not discard the packing material until you
have carefully inspected and satisfactorily
operated the tool.
• If any parts are damaged or missing, please
call 1-800-317-7833.
WARNING:
If any parts are
damaged or missing, do not operate this
product until the parts are replaced. Use of
this product with damaged or missing parts
could result in serious personal injury.
WARNING:
Do not attempt to
modify this product or create accessories not
recommended for use with this string trimmer.
Any such alteration or modication is misuse
and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
Do not install the
battery until assembly is complete. Failure to
comply could result in accidental starting and
possible serious personal injury.
PACKING LIST
Not for Reproduction

Snapper SC60V Specifications

General

Brand	Snapper
Model	SC60V
Category	Chainsaw
Language	English