Snapper SG 5000 - Page 10

(4) My centrifugal clutch smokes and burns the belt.
In all probability the inner shoes of the rotor assembly are worn. A view of the clutch pulley is given on
page 11. VYou may also have a loose drive belt. If you attempt starting your shredder with heavy material
in the grinding chamber, the rotor may refuse to turn when the engine comes up to rpm, thus burning the
clutch. Check the shredding chamber for cleanliness.
(5) My rotor pulley comes loose and falls off.
The pulley hub has two set screws, one directly over a key. Be certain the key is still in place. In all
probability it is not. Apply E.V. grade Loc-tite to each set screw and tighten down hard. Be certain the
rotor pulley lines up with the drive pulley to prevent undue belt wear and to prevent the belt from rolling
over or slipping off.
RIGHT WAY WRONG WAY
Do clear discharge area of machine with spade. Don't clear discharge with hands. Never place
rake or long handle tool. any part of your body in discharge area.