Snapper SG 5000 - Lubrication and Maintenance; Removal and Disassembly

CENTRIFUGAL CLUTCH SERVICING INSTRUCTIONS
LUBRICATION AND MAINTENANCE
The centrifugual clutch on this machine is permanently lubricated and does not require
oil or grease. If after long periods of use, the pulley assembly wobbles excessively, check the
bushing in the pulley assembly. This assembly may need replacement.
REMOVAL AND DISASSEMBLY
(1) Loosen set screws and remove clutch from the engine crankshaft.
(2) Remove retaining ring and slide off rotor assembly.
REASSEMBLY
(1) Reassemble the pulley assembly w/bushing to the rotor assembly, secure with retaining ring.
(2) Slide clutch over engine crankshaft. NOTE: Make sure the built-in key in the rotor assembly is lined up
with the keyway in the engine crankshaft, secure witii set screws.
(3) (2)
(D
CLUTCH PARTS LIST, 3/4" BORE - 5 HP ENGINE
Complete Part #40827
Key No.
Part No.
Description
Quantity
1
40875
Pulley Assembly w/Bushing
1
2
40876
Rotor Assembly
1
3
77681
Set Screw
2
4
40877
Retaining Ring
1
12