STEERING GROUP
Footnotes:
TP 400-5042-2-GC-N
Manual No. 7006179TURF / TRAIL CRUISER
SERIES 1
17
Part No Descri
tionItem Qt
Note
1 1725024 1 CENTER CAP, Steering Wheel
2 7092036 1 NUT, M16 x 2 thread Hex, GR 5 in hardware bag
3 7092042 1 WASHER, 16mm Split Lock in hardware bag
4 1722318 1 * STEERING WHEEL (w/cross drilled hole)
4 7078088 1 STEERING WHEEL, UV-2 (w/40 tooth splined hole)
5 1678381 1 COVER, Steering Shaft
6 7072638 1 COVER, Steering Shaft 4” long
7 7090845 1 * ROLL PIN, 5/16 x 1-1/2”
8 7027496 1 * COLUMN, Steering (w/cross drilled hole)
8 7078191 1 COLUMN, Steering (w/40 tooth spline)
9 7091187 1 NUT, 10mm-1.50 Hex Nyloc
10 7091184 1 SCREW, M10-1.50 x 40mm Hex Head Cap
11 7028075 1 ASSEMBLY, Rack and Pinion Steering
12 7090559 2 NUT, 1/2-20 Hex Jam, GR 5 or B
13 7036465 2 BALL JOINT, 1/2-20
14 7072637 4 SPACER, 1/2 I.D., 5/8 O.D. x .375
15 7091121 2 NUT, 1/2-13 Hex Nyloc or 7091922
16 7090544 2 SCREW, 1/2-13 x 2-3/4 Hex Head Cap, GR 5
17 7092079 6 INSERT, 5/16-18 Hex Threaded
18 7091905 2 BOLT, 5/16-18 x 7/8” Hex Flange Lock
19 7090188 6 WASHER, .34 x .69 x .08 Flat
20 7091315 6 WASHER, .32 x .58 x .08 Split Lock
21 7091058 4 SCREW, 5/16-18 x 3-3/4” Hex Head Cap
Note: * Used on UVG Serial #'s 50028650 thru 699 & UV Serial #'s 50029300 thru 399.
To Next Page
Loading...
