7
YOUR COMBINATION CODE
• Your factory preset combination code
is 1-2-3-4-5-6.
• It is recorded in a small envelope
wired to the door handle of your vault.
Store this combination in a
location other than your vault.
OPENING AND CLOSING
YOUR VAULT
OPENING:
1. Enter the 6-digit combination code.
2. Rotate 3-spoke handle
clockwise into the open
position and pull door open.
3. The Entry Keypad relocks
in 4 seconds after a valid
code has been entered.
4. The Entry Keypad will return
to“standby” status with a
long beep sound if there is no
operation in 10 seconds after the
system has been activated.
5. If you enter an incorrect
combination 4-times in a row, the
lock will shut down for 5-minutes.
CLOSING:
1. Close vault door.
2. Rotate 3-spoke handle counter-
clock wise to the closed position
until you hear bolts engage.
CHANGING YOUR
COMBINATION CODE
Write down and store a new 6-digit
code. (Do not store in vault).)
You cannot set the combination
code to six (6) zeros (0).
1. Open vault door and lock
it in open position.
2. Enter zero (0) six (6) times. One
beep sounds indicating the
entry is valid and the system
is awaiting a code change.
3. Enter the existing 6-digit
code. One beep sounds,
indicating the entry is valid.
4. Enter a new 6-digit code.
One beep sounds, indicating
the entry is valid.
5. Re-enter the new 6-digit code.
One beep sounds, indicating
that the code in step 4 and
5 are the same and that the
code change is successful.
6. If three beeps sound, the code
change was unsuccessful,
and the existing code is still
valid. Repeat steps 2 – 5.
7. Enter and check new code
3-times before closing door.
Note: Each step in the code change
process must be completed in
10 seconds or the system reverts
back to “standby” status.
To Next Page
Loading...