13
6. Push pin handles toward truck to unlock main pins.
(See Figure 1-25).
Figure 1-25
7. Disengage lower jack stand pin by pulling on handle.
Lower the jack stand and engage the top pin by pushing
on the handle. Make sure pin is engaged in hole by
rotating jack stand back and forth.
8. Remove controller from truck cab and plug into plow
control harness.
Figure 1-26
9. Rotate jack stand down and raise A-frame by
pressing the up button. (See Figure 1-27).
Figure 1-27
10. Disconnect power harness, replace protective caps
and back truck away from plow.
PIN HANDLE
STRAIGHT OUT
BELL
CRANK
JACK
STAND
LIFT LINK
UPPER PIN
HANDLE
To Next Page
Loading...
