26
Fluid leaking at
power unit
(continuation)
Reservoir over-full Oil will leak out of the breather cap if this is the problem. Remove hydraulic
fluid down to the fill line on the reservoir.
Pump shaft seal leaking This can be determined if there is oil leaking from the motor housing.
Remove the motor. Drain the oil out of the reservoir and remove. Remove
the pump from the base. Remove the pump seal. Install new seal. Reinstall
all components removed.
Valve block cap screw
loose
Tighten cap screw.
Reservoir fasteners loose Tighten reservoir fastener or replace if damaged.
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
To Next Page
Loading...
