20
4. Carefully drain oil from reservoir into a suitable
container and discard in a approved waste oil disposal
site.
Figure 2-2
5. Remove 3/8" Cap Screw securing Pivot Nut Plate to
Motor Mounting Plate.(See Figure 2-2)
6. Remove Nut from 1" Pivot Bolt.(See Figure 2-2)
Figure 2-3
7. Remove two 3/8" Cap Screws securing Pump unit to
A-Frame.(See Figure 2-3)
8. Loosen Band Clamp.(See Figure 2-3)
9. Tilt Power unit up and locate lock plate retaining
mounting bolts. Flatten tabs. (See Figure 2-3)
10. Remove two 3/8" Cap Screws securing Pump unit to
frame.(See Figure 2-3)
Figure 2-4
11. Remove the filler/breather cap from the reservoir.
(See Figure 2-4)
12. Remove the four Cap screws securing the oil
reservoir to the pump assembly and remove the oil
reservoir. (See Figure 2-4)
Figure 2-5
13. Unscrew the filter screen (hold it by the metal cover,
not by the screen) and clean it with a suitable solvent.
Blow dry with low pressure compressed air from the
inside.
14. Carefully reinstall the filter screen. Tighten it by hand
to avoid damaging the threads of the nylon pick-up tube.
15. Visually check that the pickup tube and filter face
down (See Figure 2-5) if not, rotate the pickup tube until it
is correctly positioned.
16. Clean the reservoir inside and out with a suitable
solvent. Carefully remove any metal particles from the
magnet inside the reservoir.
3/8" CAP SCREW
PIVOT NUT
PLATE
MOUNTING BOLTS
NEOPRENE PAD
LOCK PLATE
BAND CLAMP
3/8" CAP SCREW
LOCK PLATE
FILLER CAP
CAPS CREWS
PICK UP TUBE
O-RING GROVE
FILTER
To Next Page
Loading...