How to setup a M200 SC - DECT Base
Index:
Basics
Configure M200 SC manually
Configuring the M200 SC via Provisioning
Connecting a handset
Pairing handsets
Rename Handset
Server connection
Setting up accounts
Assign account to handset
Basics
There are two ways to set up your Snom device, manually or via " ". Provisioning offers different ways, the most common of which is via the provisioning
PBX and the also quite common way is via our " " server.SRAPS
In this section, we will look at the manual way.
Configure M200 SC manually
Enter Snom Webinterface
To set up the M200 SC manually, you first need to open the web interface in a browser and log in with the default credentials.
To access the base, enter the IP address of the base into your internet browser (e.g. ). You will find detailed http://192.168.1.100
instructions on how to do this in the following article: click here.
Connecting a handset
Read below: Connecting a handset
Setup a Server Connection
Read below: Server connection
Configuring the M200 SC via Provisioning
SRAPS
You can read instructions on how to configure a device via SRAPS in the following article: Endpoint Management - Phones
When using SRAPS provisioning M200 device require minimum configuration otherwise config will not be accepted.
Required fields:
Display name
Enable SIP account
Primary SIP server address
SIP account label
SIP authentication access password
SIP authentication name
SIP registration server address
Please check in advance that your phone has the version installed. latest stable firmware
To Next Page
Need help?
General
