SNOM-PA1 - Set-up
Configuration
1. Ensure the network is configured with DHCP
2. Plug the Ethernet cable into the RJ45 connector labelled "Port 1PoE".
a. The second RJ45 connector labelled "Port 2" is for daisy-chaining further Ethernet devices without the need for
another Ethernet cable.
Note: If no PoE available: Connect a snom-approved 5 V 10 W power adapter to the power connector labelled "5V DC".
(Not included – must be ordered).
3. Plug a speaker device (speaker wire or audio jack labeled “line out”) into the PA-1.
https://www.uc.solutions/Additional_Solutions/SNOM-PA1/SNOM-PA1_-_Set-up
Updated: Mon, 13 Feb 2023 21:25:19 GMT
Powered by
1
To Next Page
Need help?
General