Need help?Do you have a question about the Snowrex EJ-600 and is the answer not in the manual?
Explains cause and solution for overload condition.
Explains cause and solution for underload condition.
Explains cause and solution for zeroing errors.
Details Baud rate, parity, data bit, and stop bit.
Illustrates the data transmission format.
Describes pin connections for RS232C.
Lists models EJ-600 and EJ-1200.
Specifies weighing ranges for models.
States the readability for each model.
Lists linearity specifications for models.
Indicates the pan size for models.
Provides unit dimensions and net weight.
Details power requirements and adapter info.
Configures print output settings.
Sets the communication baud rate.
Configures calibration weight values.
Shows expected display during calibration.
Displays the required calibration weight.
Instruction to place calibration weights.
Describes the span calibration step.
Transition from span to zero calibration.
Instruction to remove calibration weights.
Describes the zero calibration step.
Indicates calibration completion.
Explains error handling with wrong weights.
Guides on re-calibration if errors occur.
Lists available weighing units and their settings.
Configures auto-zero correction settings.
Sets the automatic sleep mode timer.
Controls backlight behavior and timing.
Explains how to use the tare function.
Details how to perform parts counting.
Guides on using the percentage weighing function.
Explains the Hi/Lo comparator function.
Entry point for program settings.
Sets the Hi-Lo comparison mode.
Sets the lower limit for comparison.
Configures beep sound settings.
To Next Page
General
