What to do if my Snugger SF2300 flame extinguished or burner overheats?
If the flame is extinguished or the burner overheats, preventing the system from operating, disconnect the power and then reconnect it.
What to do if my Snugger SF2300 is not igniting or the flame keeps extinguishing?
If your Snugger Heater fails to ignite or the flame extinguishes, verify the following: * Ensure there is fuel in the tank. * Check all fuel connections. * Confirm the fuel pump is working. * Verify the glow pin is functioning normally. * Check for any blockages in the air inlet or exhaust.
Why is my Snugger SF2300 Heater burner overheating?
General| Power | 1500W |
|---|---|
| Heating Area | Up to 150 sq ft |
| Thermostat | Adjustable |
| Safety Features | Overheat protection, Tip-over switch |
| Voltage | 120V |
To Next Page
