5
Winterization
• Turn off and disconnect the garden hose.
• Open the handle and turn it to the "hot" position to allow the water to drain out
of the hoses and solar shower (This takes approximately 8-10 minutes). Do not
touch or turn the handle while draining, otherwise, the water will stop draining
out.
• Turn the locking ring counter-clockwise to unthread the upper stand (A) from the
lower stand (B). After this, please disconnect the hose connection. Now the water
in the solar shower can run out.
• Disassemble the lower stand (B) and pour the remaining water out of the solar
shower.
• Clean and dry all solar shower parts.
• Store all solar shower parts indoors and in a dry place during the winter season
to prevent frostbite.
Attention
• Do not use salt or other antifreezing methods.
• Recommended water pressure: maximum 3.5 bars. Under no circumstances
should the solar shower be operated by an additional pump or domestic water
supply.
• The heating of the water results in an expansion of the water, allowing the water
to escape minimally from the shower head.
• During the initial use of the shower, to eliminate plastic and oil smells, let the
water run for several minutes and clean the shower's inner parts with flowing
water.