Snuza GO! User Manual

9
7.3 Travelling
Movement from external sources such as being pushed in a pram or traveling
in a vehicle or aircraft may be detected by Go!’s sensor. Snuza Go! should not
be relied upon where external sources of movement are present.
7.4 Clothing
• Go!canbeclippedontothefoldedwaistbandofthediaperorthe 
waistband of elasticated pants, as long as the Movement Sensor (1)
touches the baby in the tummy area.
• Theremayalsobeathinlayerofclothing(egavest)betweenthe 
Sensor and the skin, but ensure that the Sensor maintains contact.
• Themonitorcanalsobeusedifbabyisdressedinlightclothing(for
example, a Babygro) over the diaper or pants to which the Go! is
attached.
• Toomuchclothingmayattenuateormufethealarm.Makesurethe
alarm can be heard if baby is covered in clothing and/or blankets.
7.5 Baby Sound and Video Monitors (Optional)
Snuza Go! can be used together with a baby sound or video monitor to extend
the distance at which the alarm can be heard.
8. SETTINGS
8.1 Audible Tick
This feature causes Go! to emit an audible ‘tick’ on each abdominal
movement. To enable the Audible tick, ensure that Go! is switched ON, and
press the MODE/OFF button (6) briefly (less than 1 second).
To increase the volume of the tick, press the MODE/OFF button once again for
medium volume and again for high volume.
To turn off, briefly press the MODE/OFF button a fourth time – Go! will give a
louder beep.
ENGLISH

Snuza GO! Specifications

General

Brand	Snuza
Model	GO!
Category	Baby Monitor
Language	English