24
same time. If door is still not opened, please ensure that if the wiring or power
supply of electric lock is installed properly or broken.
2. System password is entered but user cannot enter into various function selection of the
setting mode.
Solution: (1) System password is entered incorrectly. Please check if the following step has
been entered correctly. ＃ X X X X ＃, (X X X X represent system password), or
press ＊ button first and then enter the correct system password ＃５６７８＃.
(2) Bad wiring arrangement may affect key enter data. Please confirm that the power
supply wire and the control wire have been arranged to the space at the back of
the LCD (this is the wiring arrangement area of this unit). This is to prevent the
wires pressing on the PC board causing bad contact, short circuit and interference.
3. How to use anti-duress setting?
Solution: (1) Please change the door open mode to mode 3. Therefore, door will be opened only
by keying additional 4-digit password after sensing the registered proximity card.
(2) When the door open mode is set, press anti-duress code (user can pre-set the
anti-duress code) before entering 4-digit password, thus the anti-duress alarm will
be activated.
To Next Page
Loading...