SodaStream COOL - Installing the Co

SET UP
INSTALLING THE CO
2
CYLINDER
SODASTREAM CO
2
SCREW SYSTEM CYLINDER
1. Place the SodaStream
®
Sparkling Water Maker on a flat
sturdy surface and remove the back cover.
2. Remove seal and cap from the SodaStream CO
2
Cylinder.
WARNING! Never insert or replace the CO
2
Cylinder
while a Plastic Carbonating Bottle is installed in the
Sparkling Water Maker. This can cause the Plastic
Carbonating Bottle to be ejected or burst. Tilt the
Sparkling Water Maker forward and insert the CO
2
Cylinder in the back of the Sparkling Water Maker.
3. Gently raise the CO
2
Cylinder and tighten by turning to the
right until it is firmly held in place. WARNING!
Hand-tighten only. DO NOT use tools; this can damage
the Sparkling Water Maker or CO
2
Cylinder. This may
result in an uncontrolled flow of CO
2
gas, causing the
Plastic Carbonating Bottle to burst and result in
personal injury or property damage.
4. Reinstall the back cover. Now you are ready to create the
bubbles.
Please note that the
SodaStream
®
Jet
TM
/Cool
TM
are compatible with the
SodaStream CO
2
Screw
System Cylinder and is NOT
compatible with the
SodaStream Quick Connect
Cylinder.
1
5
COMPATIBLE SODASTREAM
CO
2
QUICK CONNECT CYLINDER
NON-COMPATIBLE
CO
2
SCREW SYSTEM CYLINDER
Use Only SodaStream
CO
2
Screw System Cylinder
4
3
2
1