SodaStream enso - Page 6

Please note that ensō
TM/MC
is only
compatible with the Sodastream
CO Quick Connect Cylinder and is
NOT compatible with the
SodaStream® CO Screw System
Cylinder or other cylinders.
INSTALLING THE CO QUICK CONNECT CYLINDER
1. Place ensō
TM/MC
Sparkling Water Maker on a
flat sturdy surface.
2. Gently pull the plastic carbonating bottle
towards you until it reaches its fully forward
position. This will allow the plastic
carbonating bottle to be released from the
Snap-Lock.
3. Remove seal and cap from the SodaStream
CO Quick Connect Cylinder. WARNING!
Never insert or replace the CO Quick
Connect Cylinder while a Carbonating Bottle
is installed in the Sparkling Water Maker. This
can cause the Carbonating Bottle to be
ejected or burst.
4. Raise the cylinder handle.
5. Open the cylinder compartment.
6. insert the CO Quick Connect Cylinder into the
cylinder compartment of the Sparkling Water
Maker.
7. Close the cylinder compartment.
8. Lower the cylinder Handle.
9. Place the drip tray on the base of your
Sparkling Water Maker.
Now you are ready to create the bubbles.
6
7
9
4
5
SODASTREAM
®
CO QUICK CONNECT CYLINDER
SET UP
NONCOMPATIBLE
CO SCREW SYSTEM CYLINDER
COMPATIBLE SODASTREAM
CO QUICK CONNECT CYLINDER
A
B
2
A
B
3
8
5