SodaStream FIZZI - Installing the CO₂ Cylinder

1. Place the SPIRIT
TM
Sparkling Water Maker on a flat sturdy surface in an upright
position. Remove the carbonating bottle if it is installed in the Sparkling Water Maker.
Never insert or replace the cylinder while a carbonation bottle is installed in the
Sparkling Water Maker. Remove the back cover by pressing on the top of the back
cover and pulling it away from the body of the Sparkling Water Maker. Set the back
cover aside.
2. Remove seal and cap from the SodaStream CO
2
cylinder. Tip the Sparkling Water
Maker forward and insert the cylinder into the back of the Sparkling Water Maker
by first inserting the base of the cylinder followed by the body of the cylinder then
tilt it towards the body of the Sparkling Water Maker.
3. Return the Sparkling Water Maker to the upright position with the cylinder valve
inside the cylinder holder. Gently push the cylinder up and screw to the right while
applying pressure until it is firmly held in place. Hand-tighten only; DO NOT use
tools.
4. Reinstall the back cover by fitting the upright tab at the bottom of the back cover
into the slot at the rear of the base of the Sparkling Water Maker and pushing the
cover into place onto the back of the Sparkling Water Maker. Now you are ready to
create the bubbles.
INSTALLING THE CO
2
CYLINDER INSTALLING THE CO
2
CYLINDER