SodaStream Source - Source Overview

1
5
SET UP
INSTALLING THE CO
2
CYLINDER
SODASTREAM
®/MD
CO
2
SCREW SYSTEM CYLINDER
1. Place the Sparkling Water Maker on a flat sturdy
surface and remove the back cover.
2. Remove seal and cap from the SodaStream CO
2
Cylinder. WARNING! Never insert or replace the CO
2
Cylinder while a Carbonating Bottle is installed in
the Sparkling Water Maker. This can cause the
Carbonating Bottle to be ejected or burst. Tilt the
Sparkling Water Maker forward and insert the CO
2
Cylinder in the back of the Sparkling Water Maker.
Gently raise the CO
2
Cylinder and tighten by turning to
the right until it is firmly held in place.
WARNING! Hand-tighten only. DO NOT use tools;
this can damage the Sparkling Water Maker or CO
2
Cylinder. This may result in an uncontrolled flow of
CO
2
gas, causing the Carbonating Bottle to burst
and result in personal injury or property damage.
3. Reinstall the back cover. Now you are ready to create
the bubbles.
Please note that the
SodaStream
®/MD
Source
TM/MC
is
compatible with the
SodaStream
®/MD
CO
2
Screw
System Cylinder and is NOT
compatible with the
SodaStream
®/MD
Quick Connect
Cylinder.
COMPATIBLE SODASTREAM
®/MD
CO
2
SCREW SYSTEM CYLINDER
NON-COMPATIBLE
CO
2
QUICK CONNECT CYLINDER
Use Only SodaStream
®/MD
CO
2
Screw System Cylinder
1
2
3
A
1
2
B