While using the bike light as a portable charger, there is no LED indicator to show the
charging status. However, if the bike light has a low battery level, the LED indicator
will flash red.
Operation Instructions
ON/OFF: Press and hold the switch to turn the light on or off. Note that when turning off the light by
holding the switch, the smart mode will also be disabled.
BATTERY LEVEL CHECK: Single-click the switch to check the current battery level. The indicator
will light up for 5 seconds.
CHANGE BRIGHTNESS LEVEL: When the light is on, single-click the switch to cycle through
Low, Medium, High, and Turbo modes. The selected mode is activated when the switch is released.
DIRECT ACCESS TO STROBE MODE: When the light is on or off, quickly double-click the
switch to activate Strobe mode. To return to the previously used mode, single-click the switch again.
DIRECT ACCESS TO SMART MODE: When the light is on or off, quickly triple-click the switch to
activate Smart mode. The light blinks once, and the LED indicator stays on for 3 seconds to signal that
you have entered Smart mode. To turn off Smart mode, triple-click the switch again. The light blinks
twice to signal that you have turned off Smart mode.
SMART MODE: When the BS01 is on, the LED indicator will light up if the light does not detect any
movement. The bike light will turn off automatically after 30 seconds of no movement, and turn on
again when it detects motion.
Safety Instructions
The BS01 is a powerful bike light. Do not point it directly at a person as this can
cause retinal damage. Keep it away from children to prevent accidents. Strobe
mode may trigger seizures in individuals with photosensitive epilepsy.
When operating the BS01 for an extended period of time in high-powered modes,
the light will heat up quickly. This is normal.
To prevent damage, avoid hitting or dropping the light.
The battery is already installed. Please do not attempt to remove the battery.
Troubleshooting and Maintenance
Store the light in a cool and dry place to avoid damage caused by humidity or
extreme temperatures.
Keep the light away from direct sunlight or other heat sources when not in use.
Do not disassemble the light or attempt to repair it yourself, as this may void the
warranty and cause damage to the light.
To Next Page
Loading...