SoFlow Flowboard Pop - Faults and Clearing Methods

copyright by www.flowboard.ch 24
Fl
4.5 Normal faults and clearing methods
Symptoms
Possible Reasons
Solutions
The Flowboard Pop
does not move after
start.
The brake is not fully reset,
which will cut off the power.
Reset the brake in position.
Riding speed is low.
Battery is low.
Charge the scooter.
The Flowboard Pop
do not work.
Battery is low.
Charge the scooter.
The motor will open
and close by itself.
Battery life is over.
Change the battery.
Controller is broken.
Change the controller.
Battery connection is not well.
Adjust the connectors of
battery and controller.
Riding range is short
for one charge.
Battery life is over.
Change the battery.
The battery can not
be charged or is
charged slowly.
Voltage is not right.
Maintain or change the
battery.
The Flowboard Pop
can not be charged.
Battery life is over
Change the battery.
Charger can not output the
power.
Change the charger.
The charging port is damaged.
Change the charging port.