Need help?Do you have a question about the Soil-Max Gold Digger Stealth ZD and is the answer not in the manual?
Important safety reminder to call the national 'call before you dig' number before operating the plow.
Details the various applications for the Gold Digger, including adding tile, new systems, and utility lines.
Identifies and labels the main parts of the pull-type Gold Digger plow for user reference.
Identifies and labels the main parts of the 3-point hitch Gold Digger plow.
Details the identification of the down-pressure manifold and proportional control valve.
Explains how to find and record the plow's serial number for insurance purposes.
Guidance on selecting an appropriate tractor based on weight, tires, and soil conditions.
Illustrates the proper and improper alignment of the 3-point hitch arms for safe operation.
Explains the purpose and correct positioning of the toplink hydraulic cylinder.
Instructions on disabling the tractor's draft control for proper plow operation.
Warns against using a quick hitch with the 3-point model due to geometry issues.
Details pioneer hydraulic fittings, connections, and the importance of fluid direction (P/T).
Emphasizes cleaning fittings to prevent valve malfunction due to dirt or debris.
Procedure for setting the water level to ensure the plow shoe is at 0% slope.
Covers initial setup for pull-type operation, focusing on drawbar placement.
Explains the correct tractor remote detent for hydraulic valve operation.
Step-by-step guide on operating the pull-type plow's wheels and float switch.
Presents the electrical schematic for the down-pressure manifold, emphasizing wire placement.
Step-by-step instructions for removing and replacing plow boots and shears.
How to determine when the shear needs replacement to prevent heel wear.
Guide to installing, adjusting, and operating the optional tile feeder for tile quality.
Hydraulic schematic for the pull-type plow with automatic grade control system.
Hydraulic schematic for the 3-point plow with automatic grade control system.
Hydraulic schematic for the 3-point plow without automatic grade control.
Hydraulic schematic for the pull-type plow without automatic grade control.
Instructions for connecting the Intellislope GPS plow control system.
Guide for wiring and connecting the automatic laser guidance system to the plow.
Wiring schematic for TopCon laser systems on the 3-point Gold Digger.
Wiring schematic for TopCon laser systems on the pull-type Gold Digger.
Step-by-step procedure for setting up the TopCon RD2 control box and receiver.
Wiring schematic for Apache laser systems on the 3-point Gold Digger.
Wiring schematic for Apache laser systems on the pull-type Gold Digger.
Identifies and explains the controls and indicators on the Apache control box.
Procedure to adjust the raise minimum correction for optimal plow movement.
Procedure to adjust the lower minimum correction for optimal plow movement.
Instructions on starting tile runs, including depth and speed considerations.
Guidance on using a second tractor for pulling the plow, emphasizing correct hookup.
Details the benefits and method of pre-ripping the ground before tiling.
Describes manual grade control using water level and depth chain for positive slopes.
Overview of Intellislope GPS and Laser Guided control systems for automatic operation.
Guidance on designing tile systems, considering mains, laterals, and slope.
How to use topo maps and yield data to create a drainage system design.
Steps to use a laser system to determine grade and depth for tile runs.
Formula for calculating the standard grade of a tile run.
Method to calculate depth needed to cover a reverse grade or go over a hump.
Answers questions about when to replace the plow's shear and heel components.
Clarifies hydraulic valve terms, detent, and troubleshooting common plow operational issues.
General| Brand | Soil-Max |
|---|---|
| Model | Gold Digger Stealth ZD |
| Category | Farm Equipment |
| Language | English |
To Next Page