SOL Smart Home Plc. info@solsmarthome.com www.solsmarthome.com
Always write down the PIN in a secure place. If you cannot remember the PIN, you may
find yourself locked out from the device and it will need a factory reset.
Renaming a device will help you to distinguish it from multiple devices; try to find
convenient names like 'Living room' or 'office1'.
Autoconnect will save you an extra step when launching the app.
4.3 BOTTOM MENU BAR
In the bottom menu bar, you will find the five main menu options of the SOL Remote app.
4.3.1 Scheduler menu
In the Scheduler menu, you can set the local time of the device and set night mode.
Please make sure to switch on night mode if you need to automate the device to run
silently during the nighttime. On the scheduler wheel, you can drag around the starting
point and the endpoint of what the device will consider to be nighttime. The light option
buttons above the scheduler wheel will let you leave on different light sources on the
device during the night (switched off by default).
If night mode is active, the fan speed is automatically reduced to approximately 30% of
full performance, resulting in near-silent operation. Manually changing the fan speed after
the night mode is activated will switch the device out of night mode. If you wish to go back
into night mode again, you will simply have to restart the device with the power switch
button in the top menu while making sure that night mode is activated.
4.3.2 Air management menu
In this menu, you have the opportunity to check on the current state of your device.
Maintenance-related tasks are also done here.
The top two circle-shaped switches are reserved for the two tower-modules, and only one
of them can be active at any given time ƅ the other one will always be grayed out. If you
are currently using the ionizer tower module, then you can switch it on or off. If you are
currently using the scenting tower module, you have the ability to switch it on or off and
change the spraying frequency by tapping the minute counter in the middle of the switch.
The UV lamp button will switch the UV lamps on or off inside the device.
The Silver Textile, Water Bowl, and HEPA filter counters are counting the time from the
last manual reset. Once the counters complete a cycle, you will need to manually reset
them and perform the relevant maintenance tasks as well.
To Next Page
Loading...