SOL Smart Home Plc. info@solsmarthome.com www.solsmarthome.com
4.1 FIRST USE
On the first use, the app will scan for all SOL_ONE signals available. At this point, make
sure your SOL_ONE is powered and operating as described in Part 3. Once the SOL
Remote app finds a valid signal, it will attempt to connect with the smart air care device
and will ask for a PIN. By default, every device has the PIN set to '1234'. You may want
to change this code for security reasons later on. If a valid signal does not appear, please
make sure that the two Bluetooth-enabled devices are in line of sight and within a close
range.
On the very first time of use, we ask that you navigate to the scheduler menu and tap
'SET' on the top right of the screen to synchronize the time on the device.
4.2 TOP MENU
The top menu contains three basic elements: Power switch button, User Guide button,
and the scan/device option button.
The scan button on the top right of the screen has two states. The initial state is the scan
option, and is only available if the app has not found any valid Bluetooth connections yet.
Once a connection is found, this button will read as SOL_ONE (or the default name of
your SOL_ONE device). This is also known as the device options button.
In the device options, you can scan for new devices (if any), choose between devices to
control (if more than one is connected), and change some of the basic settings of the
active device.
The basic settings are as follows:
change PIN
rename device
forget device
ask for PIN
autoconnect
Instead of describing each function, here is how to best proceed and some warnings to
avoid any inconveniences.
Security advice:
Having the device ask for a PIN and changing the PIN after first use are recommended
steps, especially if the device is not placed in your home.
To Next Page
Loading...