SOL Smart Home Plc. info@solsmarthome.com www.solsmarthome.com
3.3 INSTALLATION
1) Place the water bowl in the bottom part of the device.
2) Fill the bowl with water three-quarters full and then add the chosen additives.
Using water and additives is NOT REQUIRED to launch the device, though it is highly advisable,
as they can improve the efficiency of air purification.
a. Turn the top part (chimney) upside down and pull the filter on the fan’s frame.
b. Turn the top part (chimney) back to its normal position and place it over the
bottom. Make sure that the filter reaches the water bowl.
c. Connect the device to the adapter
d. Plug in the adapter.
Now the device is in operable state.
3) If using the ionizing or air-scenting unit, place it in the frame inside the chimney.
Gently rotate the ionizing or air-scenting unit until the magnets secure it in the
correct position.
You can read more about turning the device on/off and using its functions in Part 4. You
can read more about the air-scenting unit in Part 5.
4. SOL Remote App
The following is a detailed description of the SOL Remote app designed to remotely
connect and control a SOL_ONE device. The description will highlight its basic functions
and give some advice about the air care de-vice while leaving a degree of freedom for the
user to explore.
If you have not already done so, please go ahead and download the SOL Remote app,
by searching for 'SOL-ONE' in the App Store or on Google Play
If you are having difficulties finding the right app, please scan these QR codes to jump
directly to it on the app download screen.
App Store Google Play
To Next Page
Loading...