EasyManua.ls Logo

Sola 305 - User Manual

Default Icon
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
A Company
USER GUIDE
ups 305
250 VA, 425 VA, and 600 VA

Questions and Answers

  • J
    juan81Aug 1, 2025
    What to do if my Sola UPS is beeping continuously?
    • R
      Robert KelleyAug 2, 2025
      If your Sola UPS is emitting a continuous beep, and the green OPERATING LED is off while the red FAULT LED is on, it indicates a malfunction. The possible causes include an output short circuit, in which case you should turn off or unplug the load equipment. Another cause might be that the input voltage is out of range when the unit is turned on. In this case, turn the unit off until acceptable input voltage is restored.
  • P
    pittsjustinAug 7, 2025
    What to do if my Sola UPS is beeping rapidly and the red light is blinking?
    • W
      William JohnsonAug 7, 2025
      If your Sola UPS is beeping rapidly (one beep every half-second) and the red FAULT LED is blinking while the green OPERATING LED is on, it indicates an overloaded operation. This means the power required by the connected equipment is too high. To resolve this, remove some of the connected equipment to reduce the load level until the beeping stops.
  • D
    daniellebrownAug 13, 2025
    Why is my Sola UPS beeping every 5 seconds?
    • C
      Cameron ObrienAug 13, 2025
      If your Sola UPS is beeping once every five seconds, the green OPERATING LED is blinking, and the red FAULT LED is off, it indicates that the UPS is running on battery power. Possible causes include: 1. A utility power outage. In this case, prepare your equipment for powering down and wait for the power to return. 2. A loose plug. Make sure the power cord is securely connected. 3. A tripped circuit breaker. Reset the circuit breaker. 4. Power cord failure.
  • J
    Jessica DixonAug 18, 2025
    How to reset the replace battery alarm on Sola UPS?
    • A
      Alan LaneAug 18, 2025
      If your Sola UPS has the green OPERATING LED on and the red FAULT LED blinking, accompanied by three beeps every five seconds, it means the unit has failed the battery test. You can try to turn the unit off and then on again to reset the “Replace Battery” alarm and LEDs.
  • J
    joseph52Aug 26, 2025
    What to do if my Sola 305 UPS beeps twice every 5 seconds?
    • J
      John MedinaAug 26, 2025
      If your Sola UPS is beeping twice every five seconds, and the green OPERATING LED is blinking while the red FAULT LED is off, it indicates a low-battery condition. This is caused by very low battery voltage. Plug the unit into a working wall outlet for at least 8 hours to allow the batteries to charge. If the batteries do not recharge, the Sola UPS will not operate on battery power, or it will beep twice every five seconds immediately.

Summary

Important Notice

Trademarks

Safety Instructions

UPS Features

Quick Startup

Symbols, LEDs and Audible Alarms

Troubleshooting

Communication Port

Pinouts

Details the pin configuration of the RS232 communication port for various functions.

Specifications

Lists technical specifications such as line transient protection, safety, and EMC compliance.

Warranty

SOLA Australia Offices

SOLA;BEST Offices

Sola 305 Specifications

General IconGeneral
BrandSola
Model305
CategoryUPS
LanguageEnglish

Related product manuals