12 OPERATION
3 If you want to make sure your first cup of coffee is hot, insert the filter-
holder without coffee in it and let one or two cups of hot water run out in
order to warm the components of the coffee-maker.
4 Fit the filter you want to use, for 1 or 2 cups (5 or 6), in the filter holder
(4). Use the spoon to dispense the coffee. Its capacity is the
recommended dose for one coffee. Press the filter coffee down lightly.
5 If you would like to use coffee tablets, open the single-serving bag. Put
the 1-cup filter (5) on the filter holder (4). Put the tablet in the filter holder.
b. Starting the coffee maker
6 Next, place the filter holder (4) in the coffee-maker.
7 Make sure the filter holder is securely closed, pushing the handle firmly
from left to right, as it may drip otherwise (Fig. 2).
8 Install the cup-holder tray (13) according to the size of the cups you are
going to use (fig. 3):
A. Small cups
B. Large cups
9 Place one or two cups under the coffee outlet holes (12).
10 When the mains pilot light (1) turns green, turn the coffee extraction
selector (2) to the left until the selector mark points to the cup icon (fig.4).
The coffee will start to come out.
11 Once the required amount of coffee has come out, turn the selector (2)
back in the opposite direction to the de-pressurisation position (fig. 5) to
stop the coffee from coming out and vent the residual pressure in the
filter holder.
c. Cleaning
• If you have used ground coffee, clean the grounds by placing the filter
holder under running water.
• If you used a single-dose pod, remove the bag and put it in the rubbish.
B. STEAM
To heat any type of liquid using the steam nozzle (9):
1 Plug the coffee maker into the mains and press the switch (1). The
orange pilot light will come on and change to green once the appliance
is ready to make the coffee.
2 Next, press the steam switch (3) and wait until its pilot light comes on.
To Next Page
Loading...
Need help?
General
