SOLAC ECOGENIC - CLEANING AND MAINTENANCE; EMPTYING THE DUSTBIN; FILTER CLEANING AND REPLACEMENT; REMOVAL AND CLEANING OF BRUSHES

24 STORAGE AND STORAGE
For best performance of the robot vacuum, we recommend that you clean the dustbin and
clean the filter after every 3 uses.
EMPTYING THE DUSTBIN (11)
1 Keep the release button (12) pressed down. Remove the dustbin (11). (fig. 8)
2 Place the dustbin over a rubbish bin, pull the tab (14) to open the filter holder and empty
the contents into the rubbish bin. (fig. 9)
FILTER CLEANING AND REPLACEMENT (7)
) It is advisable to inspect the filter regularly, to check that it is working properly.
Clean the filter thoroughly if you detect a reduction in the appliance’s vacuuming
capacity.
) It is advisable to replace the filter once or twice a year, depending on how often the
appliance is used.
1 Empty the dustbin as shown in the “EMPTYING THE DUSTBIN (11)” section.
2 Remove the filter (7). Press the semi-circular holder with one hand to remove the used
filter from the holder (fig. 10)
3 Gently shake the removed filter against the side of the rubbish bin to dislodge excess
dust and dirt.
) Never use the robot vacuum without the filter (7).
4 Clean the filter using the cleaning brush (6) (fig. 11).
5 Return the clean filter, or new filter if necessary, to its holder.
CLEANING THE DUSTBIN (11)
1 Press the button (13). This releases the vacuum module (15) (fig. 12).
2 Turn the vacuum module round, release the two tabs and remove the lid.
3 Clean the interior of the bin using the cleaning brush (6) (fig. 13).
4 Use the cleaning brush to clean the vacuum module (15) and the air intake and outlet
unit (fig. 13).
) Do not clean the vacuum module with water.
5 Fit the dustbin into the body of the appliance. Press on the bin until you hear a click,
which indicates that it is properly fitted to the body.
MOP CLEANING AND REPLACEMENT (9)
) Do not use the mop on rugs, carpets or floors that are not completely smooth.
1 In such cases, remove the mop attachment (10). Turn the mop attachment and undo
the left and right tabs (fig. 14).
2 To replace the mop (9), pull it out and put a new one in its place (fig.14).
REMOVAL AND CLEANING OF BRUSHES
For best performance of the robot vacuum, we recommend that you clean the rollers and
brushes after every 3 uses.
Rollers (22) and (23)
1 Push the tab back and lift and fastening bar (fig.15).
, The rollers will be released.
2 Remove the rollers (22) and (23).
3 Clean the rollers using the cleaning brush (6) (fig.16).
4 Re-insert the rollers and replace the fastening bar, pressing it until you hear a click,
which indicates that it is fitted properly