SOLAC HU1050 - Troubleshooting

TROUBLESHOOTING 13
en
 Water must not get into the appliance; should this happen, take it to an
authorised service centre before using it again.
5 TROUBLESHOOTING
6 OBSERVATIONS
 Humidifiers using ultrasound technology produce smaller water particles
which can more easily reach the lower respiratory tracts.
This type of humidifier is therefore suitable for the treatment of
symptoms of the common cold and laryngitis.
P
ROBLEM POSSIBLE CAUSE SUGGESTION
The
appliance
is not
receiving
power
The humidifier is not
connected to the mains.
Plug the appliance into the mains.
The power socket is not
receiving power.
Check the fuses and whether or
not the socket is receiving power.
No mist
comes
out
The water tank is empty
(1).
Fill the water tank.
The fan is broken.
Call the authorised technical
service.
Some other component
of the appliance is
broken.
Call the authorised technical
service.
No mist
comes
out but
the water
tank is
full.
The selected moisture
output level is too low.
Select a higher moisture output
level.
The appliance is not
placed on a flat surface.
Place the appliance on a flat
surface.
There are scale deposits
on the transducer.
Clean the transducer using the
included brush and fill the tank
Detergent was used to
clean the tank.
Rinse the tank with clean water.
The transducer is broken.
Call the authorised technical
service.
Scale
deposits
Hard water with high
mineral content
Use distilled water.
Bad smell
Water in the tank for too
long.
Clean the tank with water and
vinegar and rinse with clean water.
Leave the tank open for some time
without the cap, in a cool place.
Libro HU1050.book Page 13 Monday, September 10, 2007 10:45 AM