SOLAC ID7840 - Operating the Water Flosser; Usage and Cleaning Guide; Nozzle Maintenance

USE:
-
clean it.
- Instert the nozzle into the unit (Fig. 2). Replace
the nozzle every 6 months for optimal results
- Press the “Mode” button (E) to select the working
mode.
*
For normal cleaning
*
For gente cleaning of sensitive gums or for
*
For cleaning, massaging and strengthen
the gums.
-
choose the soft mode (
) for a week, when you
adapt to it, you can use the mode you want.
- Lean over washbasin, hold the unit in an upright
position with nozzle tip point toward your teeth
and close slightly your lips to prevent splashing
(Fig 3).
- Turn the appliance on, by using the on/off button.
-
the teeth with the nozzle tip at a 90º degree
(Fig. 4).
- Clean between the teeth and around any braces,
crowns or bridgework thoroughly.
- Remove the water from the water tank.
- Press “On/Off” button to turn on the unit, and
drain the water off completely.
- Press “On/Off” key again to turn off the unit.
- Clean the appliance.
- In order to save energy, the appliance passes to
stand-by after 2 minutes.
- To turn it on again, you simply have to press the
on/off button.
NOZZLES
- Press the nozzle release button (B) to remove or
to replace the nozzles (Fig. 5).