-
-
-
(Original instructions)
A – Spray button
B – Steam blast button
C – Steam flow control
D – Auto-cleaning button
E – Temperature regulator
F – Pilot light
G – Filling spout
H – Spray nozzle
I – Soleplate
If the model of your appliance does not
have the accessories described above,
they can also be bought separately from
the Technical Assistance Service.
-
not affect the correct working order of
the appliance.
For a correct operation, keep the
soleplate in proper conditions; do not
operate over metal objects (ironing
board metal parts, buttons, zips etc.)
It is advisable to use distilled water,
especially if the water in your area
contains clay or if it is “hard” (containing
lime or magnesium).
Check that the lid is closed properly
before starting the appliance.
Never leave the appliance connected
and unattended if is not in use. This
saves energy and prolongs the life of the
appliance.
Never rest the appliance into a surface
while in use.
Do not use the appliance on any part of
the body of a person or animal.
Do not use the appliance to dry textiles
of any kind.
Turn the thermostat control to the
minimum (MIN) setting. This does not
mean that the iron is switched off
permanently.
-
-
-
-
-
-
-
-
-
-
Fully extend the appliance’s power cable
before each use.
Do not use the appliance if the
accessories or consumables attached to
it are defective. Replace them
immediately.
Do not use the appliance if the on/ off
switch does not work.
Do not use the appliance if any of the
switches do not work.
Use the appliance handle/s, to catch it or
move it.
Do not use the appliance if it is tipped up
and do not turn it over.
To keep the non-stick treatment in good
condition, do not use metal or pointed
utensils on it.
Respect the MAX level indicator. (Fig.1)
Disconnect the appliance from the mains
when not in use and before undertaking
any cleaning task.
Store this appliance out of reach of
children and/or persons with physical,
sensory or reduced mental or lack of
experience and knowledge.
Do not store or transport the appliance if
it is still hot.
Keeping the iron in its housing support
at maximum temperature for too long,
may cause its colour change, which will
-
-
-
-
Make sure that all products’ packaging
has been removed.
Some parts of the appliance have been
lightly greased. Consequently, the first
time the appliance is used a light smoke
may be detected. After a short time, this
smoke will disappear.
-
-
-
-
It is essential to have filled the deposit with
water to be able to work with steam.
Open water inlet lid.
Fill the deposit taking care to observe the
MAX level (Fig.1).
Close water inlet lid.
-
-
-
-
To Next Page
Loading...
