It is important to self-clean the appliance
at least once a month to remove calcium
and any other built-up minerals inside
the iron.
Fill the depository to its maximum level,
as indicated on “water fill" section.
Place the iron in the vertical position,
plug into the mains and select the
maximum temperature.
Leave the appliance to heat up until the
pilot light indicates that it has reached its
consigned temperature.
Unplug the appliance and place it in the
sink.
Press the self-clean button, and keep it
pressed down.
Let the water fl ow out through the
steam vents in the base, while lightly
shaking the appliance.
Release the button after a minute or
when the tank becomes empty.
Leave the iron in the vertical position
until it has cooled.
-
-
-
-
-
-
-
-
-
Clean the equipment with a damp cloth
with a few drops of washingup liquid and
then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or
abrasive products, for cleaning the
appliance.
Never submerge the appliance in water or
any other liquid or place it under running
water.
-
-
-
For the appliance to work correctly it
should be kept free of limescale or
magnesium incrustations caused by the
use of hard water.
To prevent this kind of problem, we
recommend the use of water with low lime
or magnesium mineralisation.
Homemade solutions are not
recommended in the decaling of this
appliance, such as the use of vinegar.
-
-
-
To Next Page
Loading...
