EasyManua.ls Logo

SOLAC Q605 - Charging the Battery; Initial Charge Requirement; Charging Environment and Voltage; Operation During Charging

SOLAC Q605
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
DESCRIPTION
A Lid
B Body
C Cover
D Blends
E Fan
F On/off
G Information light
H Charge conexion
I USB Charging cord
J Brush
K Lint container
If the model of your appliance
does not have the accessories
described above, they can also be
bought separately from the Techni-
cal Assistance Service.
Caution: A new battery is not ful-
ly charged and must therefore be
charged before the appliance is
Charge the battery at an atmos-
pheric temperature of between 4
and 40ºC.
Voltaje output of the adaptator
must be 5V, 1-2A. (not included).
A pilot light will come on to indicate
that the charger is ready to begin
charging the battery.
Approximately 6 to 8 hours are
needed for a complete charge of
the battery. Never attempt to over
charge the battery (although it is
of the battery be of 8 hours in du-
ration).
Connect the charger (h) to the jack
using the socket on the appliance.
The socket is located at the lower/
back part of the appliance.
The pilot light will come on to in-
dicate that the charger is charging
the battery.
At the end of the time period spec-
from the charger.
When the battery is charged dis-
connect the charger from the
mains supply.
NB: Do not can use the appliance
while it is connected to the charger.
INSTRUCTIONS FOR USE
Make sure that all the product’s
packaging has been removed.
Before using this product for the
full charge of batteries.
Place the garment on a smooth
surface.
Do not use the appliance on gar-
ments that are being worn in order
to avoid damage on the user or
garment.
For best results, please follow
these recommendations:
For fast remove, take the remover
circle and shave in small range re-
moving to and forth on clothes.