8
Fig.14
A - Fold Button
B - Unfold Button
Fig.15
Fig.16
Fig.17
Controller
Controller is fixed in the rear cover and it receives the signal from the control panel and transfers the
to motor, brake and bulb.
signal
Notice: Do not store the controller in the moisture environment. If the controller
by moisture, make sure to dry it before operation.
hasbeen affected
Brake
Electric Scooter install the electromagnetic brake and it can not brake by manual. You can raise the
headstock to move the scooter or pull the scooter after fold.
Motor/Transmission component
Motor/ Transmission component as a mechanical and electrical part will convert the electrical energy
rear wheel drive.
to
Remote control［automatic］ (Fig. 14)
Automatically Unfold and Fold the
scooter by remotes:
Genies install the electromagnetic brake and
it can not brake by manual. You can raise the
headstock to move the scooter or pull the
scooter after fold.
1. Press B button and do not release your hand.
2. Scooter will folding automatic (Fig.15-16 )
3. After folded completely ,you will hear “click” sound.
Then release your hand.
4. Press A button and do not release your hand.
Unfolding totally (Fig.17)
Folding operation
To Next Page
Loading...
