Solaxx RetroJet - System Reprogramming; Procedure for New Cell

11 pages

To Previous Page

Reprogramming the System

 To reset the programming of the power supply with the new cell.

 Leave pump on.

 Manually turn off Retro Jet.

 Hold down the Chlorine Level Button until 4 LED lights light up. With the lights off and

hold down it takes a few for them to come on

 Tap the Chlorine Level Button twice the lights do not move and let them turn off

 Hold down the Chlorine Level Button again until 4 LED lights back up and tap the

Chlorine Level Button once and let the lights go off.

 Manually turn on Retro Jet

 Unplug system for 30 seconds

 Re-plug back in and if the system is off tap the on/off button once.

 Allow the system to run for at least 5 minutes to remember the setting before it shuts

off