Why does my Soleus Air Air Conditioner make a sound of flowing water?
If you hear a sound of flowing water from your Soleus Air Air Conditioner, it is the sound of refrigerant flowing within the system. This is not a problem. It could also be defrosting sound in heating mode.
What to do if my Soleus Air Air Conditioner remote control does not function correctly?
If the remote control for your Soleus Air Air Conditioner isn't working correctly, first check the distance between the remote and the unit. If that's not the issue, replace the batteries with new ones and try again.
What to do if my Soleus Air Air Conditioner stops discharging airflow for 5~10minutes during HEATING operation?
During heating operation, if your Soleus Air Air Conditioner stops discharging airflow for 5-10 minutes, it is likely defrosting automatically. Mist may appear from the outdoor unit. After defrosting, the unit will continue to run automatically.
Why does my Soleus Air Air Conditioner not immediately blow out air at the start of HEAT mode?
At the start of HEAT mode, your Soleus Air Air Conditioner may not immediately blow out air. Please wait for 2-5 minutes, as the air conditioner needs time to prepare and blow out enough warm air.
What to do if The compressor indicator(red) lights on constantly,and indoor fan stops on my Soleus Air KFTHP-9-ID?
If the compressor indicator (red) lights up constantly and the indoor fan stops on your Soleus Air Air Conditioner, it means the unit is shifting from heating mode to defrost. The indicator light will turn off within ten minutes, and the unit will return to heating mode.
General| Energy Efficiency Ratio (EER) | 11.0 |
|---|---|
| Power Consumption (Cooling) | 820W |
| Air Flow (High) | 300 CFM |
| Refrigerant | R410A |
| Type | Ductless Mini-Split |
| Cooling Capacity | 9000 BTU/h |
| Heating Capacity | 9000 BTU/h |
| Power Supply | 115V/60Hz |
| Operating Temperature (Cooling) | 90°F |
Details the functions of each button on the remote control.
Explains how to operate the unit using the FEEL mode.
How to set the timer for automatic ON/OFF operation.
Explains conditions for protective device activation.
Lists common problems and their potential causes and solutions.
Visual guide for unit placement and spacing requirements.
Instructions for connecting indoor and outdoor unit cables.
Detailed steps for mounting and piping the indoor unit.
Detailed procedure for connecting refrigerant lines.
Steps to remove air and moisture from the refrigerant system.
Procedures for testing the unit after installation.
Connecting outdoor unit piping, cables, and performing air purging.
To Next Page