ENGLISH 1
Original instructions
Changes to the scope of supply in form, technology
and equipment are reserved. No claims can be
derived from any information and figures in these
original instructions.
The original packaging and, at the end of its
service life, the sprayer must be properly disposed
of according to the local environmental regulations.
The machine can be subject to national rulings for
regular review by designated offices,
as specified
in directive 2009/128/EC.
1
EC declaration of conformity
SOLO Kleinmotoren GmbH,
Stuttgarter Straße 41, D-71069 Sindelfingen,
Germany declares that the Pressure Sprayer unit
type 456, 457, 458 from production date 05/2018
onwards - corresponds to the relevant provisions of
directive 2006/42/EC of the European parliament
and the council from 17 May 2006 about machinery
and directive 2009/127/EC.
Sindelfingen, 01 May 2018
Wolfgang Emmerich, SOLO Kleinmotoren GmbH,
Stuttgarter Straße 41, D-71069 Sindelfingen
(managing director and documentation officer)
2 Scope of delivery
x Basic unit with hand valve and pressure hose
x Spray tube, pre-installed nozzle assembly incl.
nozzle
x Carrying strap
x Alternative nozzle
x Sticker for tank unit
3 Wear parts
The following wear parts are not subject to the
manufacturer's guarantee:
* All rubber parts that come into contact with
spraying liquid, * nozzles, * filters, * seals,
4 Warranty
Please observe that specific warranty conditions
are valid in some countries. In doubt, ask your
vendor.
No guarantee can be granted for any damage
caused by:
x Non-observation of the original instructions.
x Omission of necessary maintenance and
cleaning work.
x Wear and tear from regular use
x Use of unapproved working tools.
x Use of force, improper treatment, abuse or
accident.
x Manipulations by non-qualified persons or from
improper repair attempts.
x Unauthorized modifications to the device.
x Use of unsuitable spare parts or non-genuine
spare parts.
x Use of unapproved chemicals or dilutions.
x Damage caused by use in the rental business.
Any warranty work must be performed by one of
our authorised specialist vendors. Cleaning, care
and standard adjustments are not accepted as
warranty services.
For Australia only: Supplementary warranty notes
specifically for Australia
To make a claim, contact Clayton Engineering, 26
French Ave, Brendale, Q, 4500 on phone 1300 798
022 or email sales@claytonengineering.com.au.
You will be asked to provide proof of purchase and
then will be instructed on the procedure for
repairing or replacement of the product under
warranty. All costs incurred for repair or replace,
and additional claims can be discussed at this
stage.
This warranty is provided in addition to other rights
and remedies you have under law: Our goods
come with guarantees that cannot be excluded
under the Australian Consumer Law. You are
entitled to a replacement or refund for a major
failure and for compensation for any other
reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
5 Symbols
Read the original instructions thoroughly.
DANGER! Non-observation of the original
instructions may potentially cause fatal
injury.
Wear the prescribed protective clothing.
Wear protective gloves.
Wear facial protection (e.g. goggles).
Wear breathing protection.
No smoking.
No open fire.
Minimum distance from other
persons: 15 m [approx. 16 yards]
To Next Page
Loading...
