Assembly & Tyre Inflation
Step 1 - Check the package contents
carefully, making sure all parts are in good
condition; then take the scooter out of the
box in its folded state with the kickstand
down.
Step 2 - Screw the handlebar locking clasp
with an allen key until secure.
2
Step 3 - Screw the brake lever into place
with the included allen key until secure.
Brake lever
Step 4 - Insert the left handle into position
turning it clockwise to tighten; repeat with
the right handle, tightening in an
anti-clockwise direction.
Step 5 - Check the front tyre pressure is
correct. Your scooter has had puncture
sealant treatment added before sending
out to you. We inflated the tyre to the
following tyre pressure (2.5bar / 250KPA /
36PSI)
Front wheel valve
To Next Page
Loading...
