What to do if spray bars are plugged in Sommer & Maca Industries Industrial Equipment?
If the spray bars in your Sommer & Maca Industries Industrial Equipment are plugged, you should clean the spray bar tubes out with a brush and clean the holes out with a wire or drill bit.
What to do if brushes are not rotating or slowing down in Sommer & Maca Industries TTW 366 Industrial Equipment?
If the brushes are not rotating or are slowing down on your Sommer & Maca Industries Industrial Equipment, check for broken belts, the belt tension, and the motor fuse/circuit breaker.
What to do if the rinse water is dirty in Sommer & Maca Industries TTW 366 Industrial Equipment?
If the rinse water is dirty in your Sommer & Maca Industries Industrial Equipment, drain the tank, clean it thoroughly, and then replenish the water.
What to do if rinse nozzles or holes are plugged in Sommer & Maca Industries Industrial Equipment?
If the rinse nozzles or holes are plugged in your Sommer & Maca Industries Industrial Equipment, visually inspect them and clean with a cleanout brush and wire (for holes).
What to do if there is cold water in the detergent tank of Sommer & Maca Industries TTW 366?
If there is cold water in the detergent tank of your Sommer & Maca Industries Industrial Equipment, check the temperature setting and the heater fuses, and allow sufficient warm-up time.
What to do if the brushes are worn on Sommer & Maca Industries TTW 366 Industrial Equipment?
If the brushes are worn on your Sommer & Maca Industries Industrial Equipment, adjust the brushes so the worn areas contact the glass.
What to do if blower tube have blockage in the slot(s) in Sommer & Maca Industries TTW 366 Industrial Equipment?
If the blower tube has a blockage in the slot(s) in your Sommer & Maca Industries Industrial Equipment, run a piece of glass with the blower tube covers removed to observe any blockage.
What to do if the rinse water is alkaline or hard in Sommer & Maca Industries Industrial Equipment?
If the rinse water is alkaline or hard in your Sommer & Maca Industries Industrial Equipment, drain the tank and clean it. Also, test the water hardness.
What to do if there is improper detergent concentration in Sommer & Maca Industries TTW 366?
If there is improper detergent concentration in your Sommer & Maca Industries Industrial Equipment, consult the manufacturer’s recommendations for proper use of detergent.
What to do if brushes are not contacting the glass in Sommer & Maca Industries Industrial Equipment?
If the brushes are not contacting the glass in your Sommer & Maca Industries Industrial Equipment, adjust the brushes for wear or glass thickness. See the Maintenance section for details.
General| Brand | Sommer & Maca Industries |
|---|---|
| Model | TTW 366 |
| Category | Industrial Equipment |
| Language | English |
To Next Page