1 Safety
1.1 Intended use
The roller door control unit RDC vision may only be used:
• to control motors in roller doors (max. motor power: 600 W);
• according to the instructions and safety information provided in
these installation and operating instructions.
Any other use is considered improper use. The manufacturer is not
liable for damage resulting from improper use.
The roller door control unit
RDC vision (hereafter “control unit”) may
not be used in conjunction with motors in roll-up grille doors.
1.2 Symbols used
All safety instructions are accompanied by signal words. These signal
words indicate the level of danger and/or severity of injury and/or
property damage that may be incurred in the event of failure to
comply with the instructions and/or safety information.
• Danger indicates an imminent danger,
causing: grave injury/death.
• Caution indicates potential danger,
causing: minor injury or property damage.
For information and useful tips.
1.3 General safety instructions
Persons operating or working on the control unit must have first read
and understood these installation and operating instructions and
ensure compliance with all instructions and safety information.
Work on the control unit, such as installation, connection and initial
operation, may only be carried out by a fully qualified electrician.
Always keep the installation and operating instructions within easy
reach.
Always ensure compliance with local accident prevention regulations
and current standards.
Always ensure compliance with the Employer’s Liability Rules
“Power-operated windows, doors and gates – BGR 232” (only applies
to operators in Germany).
RDC vision
en4
To Next Page
Loading...