Need help?Do you have a question about the SOMMER RDC vision and is the answer not in the manual?
General| Type | Control Unit |
|---|---|
| Radio frequency | 868.8 MHz |
| Protection class | IP54 |
| Operating Temperature | -20°C to +60°C |
| Housing Material | Plastic |
Specifies the authorized use of the RDC vision control unit for roller doors.
Outlines essential safety rules for operating and working on the control unit.
Provides safety guidelines for the use of the remote control system.
Details the electrical connection of the motor to the control unit.
Guidance on connecting electrical and optical safety contact strips.
Wiring diagrams for one-way and 2-wire photocells.
How to enable run time monitoring and program handheld transmitter buttons.
Lists all components included in the RDC vision control unit package.
Provides specifications such as frequency, temperature, power, and dimensions.
Gives instructions for storing the control unit safely and correctly.
Step-by-step guide for mounting the control unit housing.
Detailed instructions for wiring the control unit to power and motor.
Procedure for closing the control unit housing after installation.
How to set up dead man or hold to run modes for the operator.
Procedure to verify the motor operates in the correct direction.
Instructions for configuring the motor's end position limit switches.
Guide to setting run times and enabling monitoring.
Defines how the operator reacts to obstacles detected by safety devices.
Adjusting the duration of the early warning light before door movement.
Enabling and configuring the automatic door closing feature.
Wiring instructions for internal and external warning lights.
How to connect 2-way and 3-way buttons to the control unit.
How to connect a pre-end position switch.
Wiring diagrams for various types of photocells.
How to connect an emergency STOP switch for immediate safety.
How to assign Open, Stop, and Close functions to transmitter buttons.
Configuring the function to open the door only partially.
Instructions for operating the door using the buttons on the unit.
Guidelines for operating the door with a programmed handheld transmitter.
How to check the total number of door cycles using the unit's LEDs.
Schedule and procedure for regular safety device inspections.
Explains how LED and lighting blink codes indicate operating modes or faults.
Details the connections and functions for terminal strip 1.
Details the connections and functions for terminal strip 2.
Details the connections and functions for terminal strip 3.
To Next Page
