SOMMER RDC vision - Installation Procedure; Installing the Housing

15
3. Installation
3.1 Installing the housing
1
2
220
90
Ø6mm
4x
3
4
Recommendedscrewdiameter:6mm.The4screwsandtheplugsrequiredfor
wall mounting are not included in the scope of delivery.
Install the housing upright on an even surface, with the cable conduits facing downwards.
Ensure that the housing is not distorted when mounting, so that the cover seals properly
when closed.
Usethexingpointsprovidedforscrewingonthehousing.Donotdrillthroughtherear
wall of the housing.
Dry any moisture that enters into the housing with a fan.